Shark Party Printable Popcorn Holder


Shark Party Printable Popcorn Holder #popcornholder #sharkweek #sharkparty #sharkcraft
Next week is Shark Week and we shall be celebrating in style with our Shark Party Printable!

Our first version of this fun printable was a mermaid tail, which we made for Red Ted Art.
My kids and I had so much fun with it that we decided we just had to make a shark for
shark week! We’ll be reading shark books, this one is one of our favorites, doing some
shark crafts and finding some shark movies to sit down and make good use of our
popcorn holders.

We hope you enjoy them! Enter your name and email below to sign up to our fun
newsletter, filled with creative crafts and our latest printables, and I’ll send the you our
Shark Party Printable Popcorn Holder as a gift. (say that 3 times fast!)


SHARK PARTY PRINTABLE SUPPLIES:


This blog post contains affiliate links.

  • Paper to print on, we recommend 65lb weight or heavier
  • Scissors
  • Tape
  • Craft Knife
  • Shark Party Printable – Enter your name and email below to sign up to our fun
    newsletter and I’ll send the you our Shark Party Printable as a gift.

Shark Party Printable materialsSHARK PARTY PRINTABLE, THE HOW TO:


1. Cut out your shark tail and fin.
Shark Party Printable cut it out

2. Next, cut the dotted line on the tail, and fin, which you can see in the picture below.
Shark Party Printable cut tail     Shark Party Printable cut fin

3.
 Now use a craft knife to cut the dotted line in the middle of the tail, this is where the
fin will go.
Shark Party Printable cut back

4. Take your fin and push it through the underside of the tail until it pops out through
the top.
Shark Party Printable put fin through back

5. Now fold and tape the 2 tabs down, folding 1 in one direction and the 2nd in the other
direction.
Shark Party Printable tape fin

6. Next it’s time to fold it into a cone. Before you do this I recommend having some tape
close by since you’ll need to tape it right after. We found the best way to make the cone
was to fold the part that you just cut (with the dotted line) under the other side. Get the
shape you want then grab a piece of tape.Shark Party Printable fold

7. Tape down the bottom of the cone first, to the backside of the tail. Then tape up the
sides. I just used 1 piece of tape in the middle.
Shark Party Printable tape bottom     Shark Party Printable tape middle

8. Finally trim any excess off the top of the cone, and fold some tape over the seam.
Shark Party Printable trim     Shark Party Printable tape over edge

You’re done! Fill with popcorn and enjoy!
Shark Party Printable finished

SHARE YOUR SHARK PARTY PRINTABLE:

Spread the word and Pin and Facebook share with your friends!

Shark Party Printable Popcorn Holder #popcornholder #sharkweek #sharkparty #sharkcraft

Shark Party Printable Popcorn Holder #popcornholder #sharkweek #sharkparty #sharkcraft

HERE ARE SOME OTHER PROJECTS YOU MIGHT LIKE:         
ice cream card cover

Ice Cream Cone Card Printable

Mermaid Party Popcorn Holder

Mermaid Party Popcorn Holder

3 Comments

  1. Pingback: Mermaid Movie Night Printable Popcorn Holder - Red Ted Art's Blog

  2. Pingback: Shark Craft Ideas for Preschool - Red Ted Art's Blog

Comments are closed.